D2B Wii - missing some pins is it? Here’s the fix to mod
If you’re fond of souping up
your Wii, you might notice something missing in the D2B model. Apparently some of the pins have been cut, preventing the easy install of a mod chip (’course, this is nothing new - such things were reported in 2007). To wit:
…There are two technique for installing a mod chip in these systems, you can simply solder the small stub back onto the pad where it should go. Or you can grind away some of the top of the chip so that you can solder to the wires that are located in the chip.
“Here is how I handle these cut chips without grinding…
* Strip some 30gauge wire and flux it and tin it really well.
* Apply flux to the cut area on the chip.
* Steadily hold the wire vertically so that the wire makes contact with the solder pad on the board and the stub where the leg was cut.
* Apply your iron on the wire pressing it onto the stub/chip.
* Cut extra wire, install mod chip as normal and test.
* Once verified as working apply some hot glue just to make sure nothing moves.”…MORE…
Kinda makes me wish I had paid more attention in shop class (do they even have those nowadays?).
And if you’re looking for some Wii modding resources, check out:
ThankYouVeryMuch!
Owlbert
ps - looking for some nifty Wii mod tools? Enjoy:
5M BLUE KYNAR WIRE XBOX PS2 WII MOD 5 Metre for Modding
No Comments, Comment or Ping
Reply to “D2B Wii - missing some pins is it? Here’s the fix to mod”